SmartCJ Support Forum

Hello,

Is Test positions end the value from the beginning or from the Test Position Start?

Ie If i have Test Position start = 15 and Test position end = 20, Will it have 5 testing spots or 20 testing spots?

"the value from the beginning "

"Test positions end" should be greater then "Test positions start"

I did some tests.

I put test position start at 30 and test position end at 20. The testing thumbs were from spot 30 to 50.

I put test position start at 30 and test position end at 50. The testing thumbs were from 30 to 80.

I've checked that part where it selects places for test thumbs

$rand_place = mt_rand($rot_settings['test_positions_start'], $rot_settings['test_positions_end']);

so it should be ok

Are you sure ?

Yes I'am.

ok, explain plz how you test it

For example i put 30 test positions start and 20 test positions end. Galleries with 0 views are between spot 30 and 50. How can i check in "List Thumbs" which galleries are in testing mode?

i put 30 test positions start and 20 test positions end.

"Test positions end" should be greater then "Test positions start"

admin wrote:

i put 30 test positions start and 20 test positions end.

"Test positions end" should be greater then "Test positions start"

Yes i know this. But i noticed when i put start = 30 and end = 20 testing thumbs ( thumbs with 0 views or very few views ) were between spot 30 and 50 and when i put start = 30 and end = 50, testing thumbs were betweend spots 30 and 80.

ok, how do you know that those thumbs are tested\not-tested ones?